6 easy steps to bike pedalling technique supremacy
Expert tips on how to nail your pedalling technique and cycle like a pro.
Written by Ellie Ross
5 min readPublished on
At the risk of eliciting a response along the lines of "No sh*t Sherlock!", pedalling is absolutely key in cycling. It's as crucial to success on the saddle as it gets – and there are a surprising number of factors that come into play. We caught up with two cycling experts to get the lowdown on how to pedal properly and improve your skills on the pedals.
Hannah Reynolds is a Saddle Skedaddle guide, cycling author and journalist, and Barney Wainwright is a research fellow and applied sports scientist at Leeds Beckett University and the brains behind Wattbike's Pedalling Effectiveness Score.
It might sound obvious, but having the right set-up will put you on the road to a good ride. “It’s important to be set up on the bike properly to allow proper functioning of the muscles," says Wainwright. "Ideally book a session with a qualified bikefitter to get set up optimally if possible. If a cyclist reaches a plateau in their cycling technique or can not address a large left-right imbalance, a poor set-up can often be responsible."
2. Play with cadence
There is a lot of research around the optimum cadence (pedalling rate). In the early 2000s, high cadences became fashionable, in thanks partly to Lance Armstrong who favoured fast leg speeds. It was seen again in 2013 when Chris Froome launched a successful high cadence attack on the slopes of Mont Ventoux.
Wainwright says: “Beginners should not try to push cadences too high to begin with. Keep at a cadence that is manageable but over time look to increase this. Being comfortable – a cadence of 90 to 100 RPM is a good target – will improve the ability to sustain cycling over long periods of time and distances."
Reynolds adds: “Forcing yourself to pedal faster than you are comfortable with will not improve your results. However, if you are slowly chugging along at 50 or 60 rpm, you will benefit from practicing at an increased cadence – it will do your knees a favour if nothing else!
“Play with cadence, doing fast spin-ups and slow cadence climbs. Professional cyclists have a beautifully smooth, fast, effortless technique, known as “souplesse”. You can increase your souplesse with a few drills. Practice spin-ups, where you start in a light gear and then pedal as fast as you can and hold it for thirty seconds. This will gradually increase your maximum cadence and develop your ability to do this without bouncing around on the saddle. Make this part of your warm-up on every ride."
3. Aim for even power distribution – and try mountain biking
Equal power distribution between each leg is important, and you should aim for 50 percent of power production from each leg. The distribution of forces across the pedal stroke has a huge impact on efficiency, which in turn can increase power and bike speed.
Reynolds says: “Mountain bikers have the most even transfer of power of all cycling disciplines, because they need to apply power evenly throughout a pedal stroke to maintain grip on technical surfaces. Using a turbo trainer can allow you to get away with stamping, piston-like leg action. If you really want to perfect your technique, you could invest in a Wattbike; their on-screen graphic gives immediate feedback on how you are pedalling and encourages you to achieve a more even power production throughout your pedal stroke.”
Because you are aiming for equal power distribution in each leg, it’s important that they are both as strong as each other. Reynolds says: “Single leg exercises that force each limb to work individually, rather than being carried by the other, is important.” Wainwright adds: “Initially try not to focus on both left and right sides at once – this can be quite confusing. Start with a focus on one side and then the other, and then alternate the focus on each side within one session. As the cyclist becomes more skilled it is easier to focus on left and right sides at the same time.”
5. Pull your pedals in semicircles
Wainwright says cyclists should focus on pulling (instead of the pushing) their pedals, using a semicircular motion. “Normally the most important aspect of pedalling is to pull backwards at the bottom of the pedal stroke. As the pedal moves towards the bottom switch from a pushing down motion to a pulling back movement. Cyclists are often told to try to pedal in circles. This should be avoided. It should be more like two semicircles pushing down then pulling back – a left semi circle followed by a right semicircle, with a seamless transition from the left pull back to the right push down. Then repeat on the other side.”
A strong, stable core helps maintain a good riding posture and smooth pedalling technique. Reynolds says: “You can’t fire a cannon from a canoe – for your big, powerful glute muscles to fire correctly, your pelvis and trunk need to be strong, too.
Anything you do in the gym should be specific and transferable to cycling, such as split squats and single-leg squats. Every cyclist should be able to hold a plank, do bodyweight squats and press-ups. Think of your bike saddle as a bar stool you perch on, not an armchair that you slump in.”
Fancy finding out a bit more about some essential hardware and techniques? Check out these out:
With your consent, this website shall use additional cookies (including third party cookies) or similar technologies to make our site work, for marketing purposes and to improve your online experience.
You can revoke your consent via the Cookie Settings in the footer of the website at any time. Further information can be found in our Privacy Policy and in the Cookie Settings directly below.
Privacy Preference Center
When you visit any website, it may store or retrieve information on your browser, mostly in the form of cookies. This information might be about you, your preferences or your device and is mostly used to make the site work as you expect it to. The information does not usually directly identify you, but it can give you a more personalized web experience. Because we respect your right to privacy, you can choose not to allow some types of cookies. Click on the different category headings to find out more and change our default settings. However, blocking some types of cookies may impact your experience of the site and the services we are able to offer.
More information
Manage Consent Preferences
Strictly Necessary
Always Active
These cookies are necessary for the website to function and cannot be switched off in our systems. They are usually only set in response to actions made by you which amount to a request for services, such as setting your privacy preferences, logging in or filling in forms. You can set your browser to block or alert you about these cookies, but some parts of the site will not then work. These cookies do not store any personally identifiable information.
Performance
These cookies allow us to count visits and traffic sources so we can measure and improve the performance of our site. They help us to know which pages are the most and least popular and see how visitors move around the site. All information these cookies collect is aggregated and therefore anonymous. If you do not allow these cookies we will not know when you have visited our site, and will not be able to monitor its performance.
Third Party Content Cookies
These cookies may be set through our site by third-party providers of third-party content that is embedded on our site. They may be used by those companies to load, display, or in other ways to enable you to use that content. As this third-party content is provided by autonomous companies on their own responsibility, those companies may also use these cookies for their own additional purposes, such as marketing. Please refer to the privacy policies of those companies for that information. If you do not allow these cookies, you will not be able to use this third-party content embedded on our site, such as videos, music, or maps.